News RSS

Question: My HPA-tapped pistol double-feeds or misfeeds every few shots. I've confirmed the regulator pressure is correct for the field limit. What else causes this? Answer: Assuming your HPA regulator is locked to the correct output pressure (typically 100–130 PSI for most pistols), the culprit is almost always the magazine-to-adapter interface. HPA adapters replace the gas reservoir and valve assembly, but they still rely on the magazine’s original follower, spring, and feed lips to present BBs to the nozzle. If any of those components are worn, dirty, or mismatched to the adapter’s feed geometry, the cycle timing breaks down. First,...

Question: What is the difference between a fixed and an adjustable HPA nozzle, and which one should I choose for my gas blowback pistol conversion? Answer: The distinction lies in how the nozzle interfaces with the hop-up bucking and feeds BBs. A fixed nozzle is machined to a single, specific length. It is a "drop-in" solution designed for one platform—say, a Tokyo Marui Hi-Capa or a Glock 17—where the geometry between the magazine, nozzle, and hop-up unit is consistent. The primary advantage is simplicity: install it, set your regulator pressure, and play. There are no set screws to loosen or...

Question: My HPA adapter feeds inconsistently or double-feeds. What are the most common causes and how do I fix them? Answer: Inconsistent feeding usually traces back to three areas: magazine seating, feed tube alignment, or nozzle length. Start by verifying the magazine locks into the adapter securely. A loose mag catch allows the magazine to sit too low, misaligning the feed lips with the nozzle. If your adapter uses an M4-style mag release, check that the catch engages fully; Primary Airsoft stocks replacement M4 magazine releases if the original wears down or bends. Next, inspect the feed tube. It must...

Question: I want to HPA-tap my Tokyo Marui Glock 17, but the only adapter I see listed is for the Glock 18C / AAP-01. Will that adapter fit my 17, or do I need a different one? Answer: The short answer: no, the Glock 18C/AAP-01 adapter will not fit a Tokyo Marui Glock 17. While they share the "Glock" name, the magazine internal geometry differs significantly. The TM Glock 17 magazine features a distinct feed lip angle, follower geometry, and baseplate locking lug position compared to the 18C/26/18C-pattern magazines used in the AAP-01. An 18C adapter forces the feed tube...

Question: Which Primary Airsoft HPA adapter fits my Tokyo Marui MK23 or Novritsch SSX23, and how do they differ in magazine compatibility? Answer: Both the Tokyo Marui MK23 and the Novritsch SSX23 share the same magazine footprint, meaning a single HPA adapter design services both platforms. At https://primaryairsoft.us/, the MK23/SSX23 HPA adapter is engineered to feed from standard M4/AR-pattern magazines, MP5 magazines, or the proprietary X9 magazines, giving you three distinct feeding options from one unit. The adapter replaces the pistol's green gas magazine base plate and routes compressed air directly into the valve system. Because the MK23 and SSX23...